#Teamspeak creating audio loopback install#

#Teamspeak creating audio loopback install#

If you do not have the application installed then install it with 'sudo apt install pavucontrol'. Now let's start to take a look at what this looks like within the Pulse Audio Volume Controller. ~ $ pactl list short sinksĠ alsa_output.pci-0000_00_1f.3.analog-stereo module-alsa-card.c s16le 2ch 48000Hz IDLEġ alsa_output.pci-0000_00_1f.3.analog-stereo.echo-cancel module-echo-cancel.c s16le 1ch 32000Hz IDLEĢ virtual1 module-null-sink.c s16le 2ch 48000Hz RUNNINGģ virtual2 module-null-sink.c s16le 2ch 48000Hz RUNNING Load-module module-loopback sink=virtual2Īfter starting and logging in to your desktop session, open a terminal and run the following command to check that your echo-cancel sink and virtual sinks have loaded: Load-module module-loopback sink=virtual1 # loopback for virtual2 - link this to 'Monitor of v1_mic_music' # 2nd loopback for virtual1 - link this to 'Monitor of Built-in Audio Analog Stereo' # 1st loopback for virtual1 - link this to your Microphone device # naftahorn - the loopbacks are the recording channels Load-module module-null-sink sink_name=virtual2 sink_properties=scription=v2_music Load-module module-null-sink sink_name=virtual1 sink_properties=scription=v1_mic_music # virtual2 - required to link with virtual1 # virtual1 - required to link with h/w microphone and an application that is playing #naftahorn - create 2 new audio sinks (i.e. # tend to pickup a lot of background noise #naftahorn - to add echo cancel on startup for recording with internal microphones that Here are the additions I added to the end of default.pa More information on pulse sinks can be found here: We do this by altering the default.pa script in the pulse folder. To start we need to add some new sinks and loopbacks to these sinks within the pulse startup configuration.